Investigation of Suzuki–Miyaura catalyst‐transfer polycondensation of AB‐type fluorene monomer using coordination‐saturated aryl Pd(II) halide complexes as initiators

Novel triarylamine‐based coordination‐saturated aryl Pd(II) halide complexes ligated by PEt₃, PCy₃, and P(o‐tol)₃ were successfully synthesized by direct oxidative addition of aryl halide to the corresponding Pd(0) precursors. Suzuki–Miyaura coupling polymerization of 2‐(7‐halide‐9,9‐dioctylfluoren‐2‐yl)?1,3,2‐dioxaborinane with these Pd(II) complexes as initiators was investigated for the synthesis of poly(fluorene)s with triarylamine end group. Pd(II) complexes with PCy₃ or P(o‐tol)₃ exhibited catalytic activity and realized the catalyst‐transfer polycondensation at 75 °C and room temperature, respectively, while the polymerization using Pd(II) catalyst ligated by PEt₃ did not proceed, which indicated that the bulky phosphine ligands could facilitate the reductive elimination and further promote the polymerization. In addition, the dimeric Pd(II) complex with P(o‐tol)₃ can convert into monomeric Pd(II) intermediate with an open coordination site, which had a higher activity. The end groups of the afforded polyfluorene were analyzed by matrix‐assisted laser desorption ionization time‐of‐flight (MALDI‐TOF) mass spectrometry, in which the Ar/H end groups are indicative of the catalyst‐transfer polymerization. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1457–1463     

Chloride‐Selective Electrodes Based on “Two‐Wall” Aryl‐Extended Calix[4]Pyrroles: Combining Hydrogen Bonds and Anion–π Interactions to Achieve Optimum Performance

The performance of chloride‐selective electrodes based on “two‐wall” aryl‐extended calix[4]pyrroles and multiwall carbon nanotubes is presented. The calix[4]pyrrole receptors bear two phenyl groups at opposite meso‐positions. When the meso‐phenyl groups are decorated with strong electron‐withdrawing substituents, attractive anion–π interactions may exist between the receptor’s aromatic walls and the sandwiched anion. These anion–π interactions are shown to significantly affect the selectivity of the electrodes. Calix[4]pyrrole, bearing a p‐nitro withdrawing group on each of the meso‐phenyl rings, afforded sensors that display anti‐Hofmeister behavior against the lipophilic salicylate and nitrate anions. Based on the experimental data, a series of principles that help in predicting the suitability of synthetic receptors for use as anion‐specific ionophores is discussed. Finally, the sensors deliver excellent results in the direct detection of chloride in bodily fluids.     

Study of blood collection and sample preparation for analysis of vitamin D and its metabolites by liquid chromatography–tandem mass spectrometry

The analysis of vitamin D status, with special emphasis on 25-hydroxyvitamin D and 1,25-dihydroxyvitamin D, is gaining interest in clinical studies due to the classical and non-classical effects attributed to this prohormone. In this research, the influence of the two steps preceding determination (viz. sample collection and preparation) on the quantitative analysis of vitamin D and its more important metabolites has been studied. Two preparation approaches, deproteination and solid-phase extraction (SPE), have been evaluated in terms of sensitivity to delimit their application, thus establishing that detection of 1,25-dihydroxyvitamin D cannot be addressed by protein precipitation. Concerning sample collection, serum and plasma reported high accuracy (above 83.3%) for vitamin D and metabolites, while precision, expressed as relative standard deviation, was below 12.9% for all analytes in both samples. Statistical analysis revealed that serum and plasma provided similar physiological levels for vitamin D₃, 24,25-dihydroxyvitamin D₃ and 25-hydroxyvitamin D₃, while significantly different levels were obtained for 1,25-dihydroxyvitamin D₃, always higher in plasma than in serum. Sample collection and treatment have proved to be significant in the analysis of vitamin D and its relevant metabolites.     

Tf2NH-catalyzed,highly regio-and stereo-selective synthesis of trisubstituted alkenes and indane derivatives from benzylic alcohols and alkenes

A reaction of benzylic alcohols with alkenes has been developed in the presence of bis(trifluoromethane)sulfonimide for the synthesis of trisubstituted alkenes and indane derivatives with high stereoselectivity.In general,benzylic alcohols react with 1,1-diaryl alkenes to afford trisubstituted alkenes,and the reaction with 1,2-disubstituted and trisubstituted alkenes affords indane derivatives through a [3 + 2] annulation reaction.     

Insight into copper-mordenite–silica mixtures (CuMOR–SiO2)

A series of ternary CuMOR–SiO₂ mixed materials were prepared by two synthesis approaches (CuMOR1–y–SiO₂ and CuMOR2–y–SiO₂). Extensive characterization was done for both series and some selected materials were tested in CO catalytic oxidation and NO reduction. The presence of CuMOR and SiO₂ segregated phases was observed in both series by XRD, suggesting that silica formation was not inhibited by the mordenite (MOR) presence. UV–Vis results exhibited that Cu ion exchange was successfully done for CuMOR1–y–SiO₂ series. In the CuMOR2–y–SiO₂ series, the amount of copper was below the sensitivity limit of EDS analysis. CuMOR1–50%–SiO₂ catalyst resulted with higher specific surface area and catalytic activity. A possible relation between reduction temperature, the increase in Cu plasmon excitation, and catalytic activity was observed.     

Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

Infinite family of transmission irregular trees of even order

Distance between two vertices is the number of edges in a shortest path connecting them in a connected graph $G$. The transmission of a vertex $v$ is the sum of distances from $v$ to all the other vertices of $G$. If transmissions of all vertices are mutually distinct, then $G$ is a transmission irregular graph. It is known that almost no graphs are transmission irregular. Infinite families of transmission irregular trees of odd order were presented in Alizadeh and Klav?ar (2018). The following problem was posed in Alizadeh and Klav?ar (2018): do there exist infinite families of transmission irregular trees of even order? In this article, such a family is constructed.     

Photoinduced C(sp3)−N Bond Cleavage Leading to the Stereoselective Syntheses of Alkenes

Herein we report a versatile Mizoroki–Heck-type photoinduced C(sp³)−N bond cleavage reaction. Under visible-light irradiation (455 nm, blue LEDs) at room temperature, alkyl Katritzky salts react smoothly with alkenes in a 1:1 molar ratio in the presence of 1.0 mol % of commercially available photoredox catalyst without the need for any base, affording the corresponding alkyl-substituted alkenes in good yields with broad functional-group compatibility. Notably, the E/Z-selectivity of the alkene products can be controlled by an appropriate choice of photoredox catalyst.     

Elucidating the Anomalous Binding Enhancement of Isoquinoline Boronic Acid for Sialic Acid Under Acidic Conditions: Expanding Biorecognition Beyond Vicinal Diols

A zwitterionic heterocyclic boronic acid based on 4-isoquinolineboronic acid (IQBA) exhibits the highest reported binding affinity for sialic acid or N-acetylneuraminic acid (Neu5Ac, K=5390±190 m ⁻¹) through the formation of a cyclic boronate ester complex under acidic conditions (pH 3). This anomalous pH-dependent binding enhancement does not occur with common neutral saccharides (e.g., glucose, fructose, sorbitiol), because it is mediated via selective complexation to a α-hydroxycarboxylate moiety forming a stable ion pair and ternary complex with Neu5Ac in phosphate buffer. IQBA expands biorecognition beyond classical vicinal diols under neutral or alkaline buffer conditions, which enables the direct analysis of Neu5Ac by native fluorescence with sub-micromolar detection limits.     

Molecular dynamics of the intramolecular 1, 3-dipolar ene reaction of a nitrile oxide and an alkene: non-statistical behavior of a reaction involving a diradical intermediate*

ABSTRACT

Potential energy surfaces and molecular dynamics of the intramolecular 1, 3-dipolar cycloaddition and ene reaction of a nitrile oxide with an alkene were performed in the gas phase and in dichloromethane with density functional theory. One hundred trajectories were propagated in the gas phase and in dichloromethane, respectively. Twenty percent of the trajectories in the gas phase involve bicyclic intermediate and the mean time gap is 472fs. A dynamically stepwise reaction is observed. In dichloromethane, more reactive trajectories were obtained and the time gap is larger than that in the gas phase.